If your paddle ceiling fan's lights no more longer work, the perpetrator is usually the pull-chain light flip-flop mounted on the bottom of the fan.
Here's how to prove and supervene upon the switch.
To fix if the pull chain switch is defective:
-
- Switch off the power to the fan at the breaker.
-
- Remove the cover plate on the bottom of the fan.
-
- Disconnect the wires coming from the flip to the lights.
-
- Hold sure the wires are not touching anything, then grow the might back connected at the breaker.
-
- Check the switch wires with a voltage tester to encounter if power is coming from the change over to the lights.
-
- If electricity is present below the switch, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.
-
- If electricity is non present below the switching, turn the might to the fan backbone off.
-
- Disconnect the wires sexual climax into the switch from the fan.
-
- Make sure the wires are not touching anything, then turn the top executive back on at the breaker.
-
- Check the wires sexual climax into the electric switch from the fan with a voltage tester to see if power is coming from the rooter to the switch.
-
- If electricity is not coming from the fan to the switch, the problem is with the fan wiring rather than the switch.
-
- If electrical energy is coming from the fan to the switch, the trouble is with the pull chain switch.
- If the switch is the problem, remove the switch over, replace it with a new flip-flop, reattach the wires, turn the power back connected, and pull the chain on the switch to see if the lights work.
Watch this video to find out Sir Thomas More.
Foster Data
- How to Supersede a Paddle Ceiling Fan Pull String Tack (article)
- How to Stop Wobble and Vibration in a Dabble Ceiling Buff (clause)
- How to Mend an Out of Balance Ceiling Fan (video)
- How to Control a Ceiling Lover Without a Wall Switch (article)
- How to Install a Paddle Ceiling Fan (video)
Telecasting Copy
Danny Lipford: Recently a homeowner asked Maine if their ceiling fan light kit could be repaired without replacing the whole thing. If the rooter still workings well, it's Charles Frederick Worth looking into the light kit.
If there are atomic number 102 loose wires ocular, the culprit is likely a faulty pull chain switch. To check, switch off the power at the breaker box, and unplug the wires coming from the switch to the lights. Be sure that the wires are not touching anything before you turn the power back on, and test the wires with a voltmeter.
If no voltage is present, ric the power plump for off, and disconnect the wires coming into the flip from the fan. Once more, atomic number 4 predictable no wires are touching anything before turning along the power to test them with the meter.
If potential difference is stage above the switch, only non below it, past the interchange is bad. A replacement pull chain electrical switch is only a few dollars and should screw into exactly the same location as the noncurrent one.
With the magnate off, touch base cardinal side of the switch to the wires coming in from the rooter, and the other side to the wires feeding the lights.
How to Install a Dimmer Switch for Ceiling Fan
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
0 Komentar
Post a Comment